Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterDoorKing Gate Installation in McKinney: What to Know First
We install, wire, and program DoorKing gate openers and full gate systems throughout McKinney, TX, and we’re typically on site within a few days of your call. A complete DoorKing gate installation on a new gate frame runs from about $2,400 to $6,800 depending on the model, gate length, and whether you’re adding keypads, phone entry, or vehicle loop detectors. Most DoorKing installs take us one full day on site, and the price is settled in writing before a single bolt is turned.
This page is for McKinney homeowners who already own a DoorKing unit, are considering one, or have a gate that needs a new operator installed correctly. Call (430) 226-4507 and a real person answers, day or night.
How DoorKing Products Fail - and How We Fix Them
- DoorKing 9150 slide operator: chain tension drift. On long driveway runs in McKinney, the chain on a 9150 stretches over the first year or two, especially through hot summers. What looks like a motor problem is almost always chain slack. We re-tension, set the limit cams correctly, and the operator runs quiet again.
- DoorKing 6050/6100 swing arms: capacitor failures after rapid cycling. Gates that cycle repeatedly, like at an HOA entrance or a busy driveway, wear out the start capacitor on these swing-arm models. The gate will hum and not move. We keep OEM-grade capacitors on the truck and can usually have it swinging again the same visit.
- DoorKing 1601 barrier gate: PCB damage from nearby lightning. Collin County gets real lightning, as any McKinney homeowner knows, and the 1601’s control board can take a hit even with a surge protector. We diagnose whether it’s the board, the loop detector, or the motor capacitor before quoting you a repair, so you’re not paying for parts you don’t need.
- DoorKing telephone entry systems (1834, 1838): relay outputs that stop triggering. The screen works, the directory scrolls, but the gate won’t open. The cause is often a worn relay on the output side, not the keypad or the phone wiring. We bench-test it on site and replace the relay rather than pushing a whole new board on you.
- DoorKing MicroCLICK transmitters: range degradation. McKinney’s newer neighborhoods have a lot of 2.4 GHz traffic from smart home equipment, and older MicroCLICK remotes lose range next to those signals. It’s a nuisance, not a failure. We’ll re-aim the receiver antenna, check for interference, and if the transmitter is genuinely worn out, a replacement is under sixty dollars.
Our DoorKing Gate Installation Process
- 1
The call. You call (430) 226-4507. A live person answers, we ask what the gate is doing (or not doing), and we schedule a time. No estimate fees, no dispatch fees to show up.
- 2
Site check. We visit the property, look at the gate weight, post condition, existing power, and what’s already on the driveway. If it’s a new install, we measure everything and talk through placement.
- 3
Parts decision. We lay out OEM DoorKing parts and quality aftermarket options where they make sense. Victor Salinas will tell you plainly which parts earn their cost and which ones don’t.
- 4
Installation. We mount, wire, and program the operator. That includes the safety photo eyes, the clutch or force settings, and the travel limits, done the way DoorKing’s install documentation specifies.
- 5
Testing. We cycle the gate through obstruction tests, remote range tests, keypad tests, and battery backup tests if you have one. We don’t leave until it opens and closes ten times without a hiccup.
- 6
The guarantee. Every job gets our 90-Day Done Right Promise in writing. If it’s not right, we come back and make it right. No paperwork, no arguing, no exceptions.
What DoorKing Gate Installation Costs in McKinney
| Scenario | Typical Price Range |
|---|---|
| DoorKing operator installed on existing gate | $900 - $2,200 |
| Complete single swing gate with DoorKing 6050 operator | $3,000 - $5,200 |
| Complete sliding gate with DoorKing 9150 operator | $3,400 - $6,800 |
| DoorKing 1601 barrier gate installed | $2,100 - $3,600 |
| Telephone entry system (1834/1838) added to existing gate | $700 - $1,500 |
What moves the price: gate length and weight, whether conduit needs to be trenched, the condition of the existing posts, and whether you need additional keypads or phone entry. Every quote is written, itemized, and agreed before work starts. Call for a free estimate and we’ll walk the site with you.
Why McKinney Homeowners Call Ironworks Gate Co. for DoorKing Work
We’ve been serving this area for over 42 years, and we still run on the same principle Victor’s shop instructor at Collin College’s Technical Campus taught him: a gate is only as honest as the weld holding it together. We’re an independent DoorKing service provider, so we have no incentive to sell you a new unit when a repair makes more sense. Our techs work on DoorKing equipment weekly, and we also service LiftMaster, Mighty Mule, and Ghost Controls, which means if your property has more than one brand on it, one visit covers everything. If it moves when it should not or stops when it should, we will find out why. And we’ll stand behind the fix in writing.
FAQs
Using an aftermarket part can void coverage on that specific component if DoorKing proves the part caused the failure. We prefer OEM DoorKing parts for boards, motors, and safety systems, and we’ll always tell you when an aftermarket option is genuinely fine and when it isn’t.
Most single-operator installs are completed in one day on site. Trenches for loop detectors or conduit runs can add a second day depending on the distance and concrete work involved.
Yes, and that’s the most common job we do. We’ll check the gate’s weight, the hinge condition, and the post integrity before recommending which DoorKing operator fits your gate. If the existing gate wasn’t built to carry an opener, we’ll tell you that too before any work begins.
That’s most often a blocked or misaligned photo eye, a loop detector that thinks a car is still on it, or a mis-set close limit. We can diagnose it over the phone in about five minutes, and most fixes are same-day without buying parts.
Yes. We’ll come out, look at the job, and give you a written quote you can keep. There’s no charge for the visit and no pressure to book on the spot. Call (430) 226-4507 and ask for a free estimate.
Written by Victor Salinas, Owner, Ironworks Gate Co. at Ironworks Gate Co., serving McKinney and nearby areas.